Fastrak transponder holder for Rear View Mirror Toyota Matrix/Corolla - image

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

0 model files

Recommended kit

—

Based on 25% main infill across listed model files

Material cost

$0.00

Filament only at roughly $24/kg PETG / ASA

Print time

—–—

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mirror Covers

Fastrak transponder holder for Rear View Mirror Toyota Matrix/Corolla

0 downloads45 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a two part FasTrak metro transponder holder that fits onto the circular shaft of my Toyota Matrix rear view mirror. I think this should be similar to Toyota Corolla's as well. Note that the fit around the rear view mirror shaft is tricky. The current design could be tightened up but be careful not to crack the clamp. The holder for the transponder is designed to be snug with the velcro stickers on the back of the transponder. If your transponder does not have those, you will have to make it thinner or put something in there for a snug fit. Also note the sketchup stl files are sometimes non-manifold so I usually fix it through netfabb and then print. The included STLs should have no problems.