Files (1)

Fiat Cup Holder.stl

STL

4.4 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 65%	100% solid	Recommendation
Fiat Cup Holder.stl	Mount / bracket	4.4 MB STL	Slice file	Slice file	Slice file	Verify orientation and support decisions in your slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Fiat 500 Cup Holder Phone Stand

0 downloads54 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability and heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

supports unlikely

Infill

65% or higher for strength and stability

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY-SA

Commercial use allowed

Attribution required

Safety/IP review

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I designed this cup holder insert to make better use of holding my phone, sun glasses and garage door opener. It does take up two cup holder spaces. See the photos to make sure it fits your model Fiat 500, I included an original press photo which shows the unusual cup holder this is made for. Fiat Logo has been traced and embossed into the model on the top and there is a through-the-model pathway designed to route the power cord cleanly from the cigarette lighter to the phone holder. The phone post is designed to hold a self-closing phone holder like this one that I purchased on amazon. It has a ball on the end of the post designed to couple with most phone holders. The diameter of the ball is 18mm. The second option allows the phone to be further away from the gear selector area, but it does hover over the parking brake - so it would be in the way if you needed to use the parking brake. I like this design because it's easier to get my iPhone into the cradle and I can still use the parking brake, it's just not quite as accessible with a phone hovering over it. If you are concerned about the parking brake in the way, I do have another model that mounts in the TomTom port here: https://www.printables.com/model/860029-fiat-500-tomtom-phone-stand Phone holder I purchased (but there are many others like it): https://www.amazon.com/dp/B0BL1S9LFJ?psc=1&ref=ppx_yo2ov_dt_b_product_details Garage Door opener slot is designed for a chamberlain/lift master garage door opener. Sunglass holder should fit most sunglasses (Maui Jims fit great here) No supports are needed, use a brim or a raft if you have print bed adhesion issues. Recommend Infill 65% or more (I print this part at 70%).