FIAT 500 Navi/GPS mount for 1/4-20 screw (tripod mount) - image

Files (1)

Navi_Plug_Screw.stl

STL

201.9 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

17g

Based on 25% main infill across listed model files

Material cost

$0.40

Filament only at roughly $24/kg PETG / ABS

Print time

28m–47m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ABS 20%	PETG / ABS 25%	100% solid	Recommendation
Navi_Plug_Screw.stl	Primary model	201.9 KB STL	15g $0.37	17g $0.40	36g $0.87	Ensure the 1/4-20 screw hole is not obstructed during printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

FIAT 500 Navi/GPS mount for 1/4-20 screw (tripod mount)

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Rather than make Yet Another Custom Mount for a specific phone, it seemed easier to adapt the navi/GPS port plug for GoPro style mounting systems. This was a simple task of slicing off the top of the original model and adding an appropriate hole for a 1/4-20 screw, which is what camera tripods use. In this case, that screw is a 1/2" 1/4-20 socket head cap screw. You will also need the GoPro tripod mount as shown in the photos, along with whatever compatible device holder you want to use, many of which are also available for download and printing. I show one (in orange) in one of the photos. This kind of screw: https://www.amazon.com/dp/B07CPJS9CQ This kind of tripod mount: https://www.amazon.com/dp/B071XVZKP1 I'd suggest this be printed in PETG or ABS, or other high temp capable material, since it will be on the dash of a car.