FJ60 FJ62 aftermarket tach bracket - image

Files (1)

Speedhut_V1.stl

STL

272.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Speedhut_V1.stl	Primary model	272.5 KB STL	Slice file	Slice file	Slice file	Ensure proper fitment with the gauge cluster before printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

FJ60 FJ62 aftermarket tach bracket

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a bracket that allows you to install a speedhut 2 1/16" tach gauge into the gauge cluster of a FJ60 or FJ62 land cruiser. Center hole is 53mm if I remember correctly and should allow for installation of similar size gauges. It will require 2 longer screws for the top of the bracket which are readily available at any hardware store (silver ones in the photo).