Ford Fiesta MK6 Windshield Fluid Reservoir Cap - image

Files (1)

Fiesta_2006_mk6_windshield_watercap.stl

STL

351.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Fiesta_2006_mk6_windshield_watercap.stl	Cover / cap	351.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Ford Fiesta MK6 Windshield Fluid Reservoir Cap

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

My 2006 Fiesta windshield water reservoir cap just crumbled in my hand. So I decided to design and print my own. This is my third attempt: in the first one, I messed up the dimensioning a bit, second one went better and actually mounted it on my car but not without some small adjustments and trims with a knife. The third model is the one attached with the adjustments already included. Unfortunately I didn't print the last version, and do not know for sure if the adjustments I made result in a snug fit. It may need more fine tuning but I believe it will work in the end as it is. In the groove of the lid I installed small foam ring for better and silent contact with the neck of the water pipe. You may fell free do edit the lid as you like:).