Ford Focus MK1 - Sunroof Shade Handle - image

Files (1)

Sunroof_shade_Handle_v4.stl

STL

1.2 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

31g

Based on 20% main infill across listed model files

Material cost

$0.73

Filament only at roughly $24/kg ASA / PETG

Print time

52m–1.4h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	ASA / PETG 20%	ASA / PETG 20%	100% solid	Recommendation
Sunroof_shade_Handle_v4.stl	Primary model	1.2 MB STL	31g $0.73	31g $0.73	73g $1.75	Ensure proper fit and tab alignment to minimize rattling

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Ford Focus MK1 - Sunroof Shade Handle

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is my version of the sunroof shade handle for the Ford Focus MK1. The original one broke and I was eager to print a new one. Originally I've printed it from PLA, but of course it shrinked because of the heat. ASA would be a great material, because it's in a hot place and it gets direct sunlight. Also... the tabs might be a little bit far and causing it to rattle but if they are closer you can't press it in place. It's pretty hard to press it in place BTW. Printing: Use at least PETG, or even better ASA. Infill should be at least 20% fast honeycomb, but rectilinear works as well. I used grey PETG. Social media links: https://www.instagram.com/n33sworkshop/ https://www.youtube.com/c/N33sWorkshop You can leave a tip to support my work. Thanks.