Files (4)

MAVERICKPHONETHINGY_-_KEYMAVERICKPHONETHINGY-1.STL

STL

65.6 KB

MAVERICKPHONETHINGY_-_MCMASTER_90055A148MAVERICKPHONETHINGY-1.STL

STL

404.1 KB

MAVERICKPHONETHINGY_-_MCMASTER_90055A148MAVERICKPHONETHINGY-2.STL

STL

404.1 KB

MAVERICKPHONETHINGY_-_PHONE_SLOTMAVERICKPHONETHINGY-1.STL

STL

154.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
MAVERICKPHONETHINGY_-_KEYMAVERICKPHONETHINGY-1.STL	Printable file	65.6 KB STL	Slice file	Slice file	Slice file	Ensure the print orientation is optimal for the phone holder's design
MAVERICKPHONETHINGY_-_MCMASTER_90055A148MAVERICKPHONETHINGY-1.STL	Printable file	404.1 KB STL	Slice file	Slice file	Slice file	Ensure the print orientation is optimal for the phone holder's design
MAVERICKPHONETHINGY_-_MCMASTER_90055A148MAVERICKPHONETHINGY-2.STL	Printable file	404.1 KB STL	Slice file	Slice file	Slice file	Ensure the print orientation is optimal for the phone holder's design
MAVERICKPHONETHINGY_-_PHONE_SLOTMAVERICKPHONETHINGY-1.STL	Printable file	154.8 KB STL	Slice file	Slice file	Slice file	Ensure the print orientation is optimal for the phone holder's design

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Ford Maverick FITS Phone Holder

0 downloads52 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Phone Holder for the rear seat FITS key slot, designed on a 2022 Ford Maverick. Sized for my particular phone and case. Countersink and holes are pre-tap size for a 6-32 x 1/2" or 3/8" flathead screw. A sheet metal screw would probably work fine too - always watch the points against your car interior! Install pics are before I cut the sides down, but otherwise the same design. New pics coming soon. In the Solidworks file, there's an optional ribbing on the rear if your printer material isn't as rigid as what I'm using, I haven't printed with it yet, myself.