Ford FITS Baofeng UV-82C Mount (2022 Ford Maverick) - image

Files (1)

Ford_FITS_Baofeng_UV-82C_Mount.stl

STL

79.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Ford_FITS_Baofeng_UV-82C_Mount.stl	Mount / bracket	79.6 KB STL	Slice file	Slice file	Slice file	Ensure the model is oriented to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Ford FITS Baofeng UV-82C Mount (2022 Ford Maverick)

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a stand / hanger to hold a Baofeng UV-82C. I designed this to work with a FITS slot attached to a box that fits in the cubby hole on the dash. The cubby hole FITS box I modified is linked below. I printed this on a Creality Ender 3 with eSUN PETG using the following settings: Print Temperature: 245 Plate Temperature (Initial Layer): 80 Plate Temperature: 70 The rest of my settings were autoapplied via the eSun Black PETG with 0.4mm nozzle extruder settings in Cura 4.13. Print time total was 11 hours 9 minutes. Fitment was tested cubby hole box and in rear center console FITS slot. Still working on the placement of the FITS connector as well as the bridge to the model body on the rear of the model Cubby hole FITS box:.