Ford FITS Cubby Phone Holder (2022 Ford Maverick) - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Ford FITS Cubby Phone Holder (2022 Ford Maverick)

0 downloads32 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a generic phone holder that goes into the cubby hole FITS slot adapter I intend for this to be used with my pixel 3/4 phones but you can modify the dimensions to fit your phone / case. I printed this on a Creality Ender 3 with eSUN PETG using the following settings: Print Temperature: 245 Plate Temperature (Initial Layer): 80 Plate Temperature: 70 The rest of my settings were autoapplied via the eSun Black PETG with 0.4mm nozzle extruder settings in Cura 4.13. Print time total was 8 hours 21 minutes. Fitment was tested in the cubby hole FITS adapter and the rear FITS slot.