FORD MONDEO LIGHT ADAPTER FOR LED LIGHT - image

Files (1)

FARA.stl

STL

3.1 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
FARA.stl	Primary model	3.1 MB STL	Slice file	Slice file	Slice file	Ensure proper layer adhesion to prevent delamination.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

FORD MONDEO LIGHT ADAPTER FOR LED LIGHT

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Greetings, I would like to offer you an adapter for installing LED daylight lamps (on your FORD MONDEO MK1). Extends the standard ones by 48-46 mm. Suitable for both left and right car headlights. Don't forget to cut the support. Also: I was printing the first abs plastic samples - but it is stratified, so I had to replace it with a more expensive CoPET. I set the slicer speed to 40, but then reduced it to 60% on the printer. Layer height - 0.2mm nozzle - 0.5mm - air blow off. IS THERE A QUESTION? MY TELEGRAM IS +380982690686 If you want to support me: The best way to say "thank you" is to send a dollar (or more) Alas, I can't accept Paypal, but I can give you the number of the card (reality of life in Ukraine) ------------------------------------------------------------------------------- Приветствую, предлагаю вашему вниманию - адаптер для установки ЛЕД ламп дневного света (на ваш FORD MONDEO MK1). Удлиняет стандартные на 48-46 мм. Подходит как для левой так и правой фары автомобиля. Не забудьте срезать поддержки. Также: Я печатал первые пробники из абс пластика - но он расслаивается, так что мне пришлось заменить его на более дорогой CoPET. Скорость в слайсере установил на 40, но потом на принтере снизил до 60%. Высота слоя - 0.2мм сопло - 0.5мм - обдув выключен ЕСТЬ ВОПРОСЫ? МОЙ ТЕЛЕГРАММ - +380982690686.