Files (1)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg PETG / ASA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| GrommetV1.stl | Primary model | 48.6 KB STL | 10g $0.24 | 11g $0.26 | 24g $0.58 | Print with the head diameter (flat face) parallel to the bed for optimal results |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Ford Parking/Turn Lamp Grommet Clip
Shared by
3DPrintedCarPartDescription
This design is for the little clips that go over your Ford's turning/parking light bulb's locating pins. These grommets then snap into two holes that secure the bottom of the lamp assembly to the chassis. Essentially, this is the part here: https://www.amazon.com/Ford-Park-Signal-Grommets-Diameter/dp/B004E6A1XW I needed two of these to fix my 2001 Sport Trac, and rather than pay for them and shipping, I designed them myself. Hopefully they are of use to someone else. I printed these out at 1:1 scale, and they fit just fine. You may need to adjust the scale depending on your printer. Head diameter (the flat face you should be printing parallel to the bed) is 13mm, if that helps. I have only tested this on my 2001 Sport Trac, but it should work for most Ford vehicles. I am not a car person, so please let me know if I am wrong! From the part information page: "Replaces Ford: N811169S,W705550-S300 F250 - F550 Trucks 1999 -; Toyota: 90075-10801,90189-06111".
Compatible Cars
Originally published on thingiverse.com by Jordan Murray (jomur123) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
