Ford tarus 2010 Start Button Holder - image

Files (1)

Tarus_2010_Start_Button_clip_Final.stl

STL

182.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tarus_2010_Start_Button_clip_Final.stl	Clip	182.4 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Ford tarus 2010 Start Button Holder

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement for the clip that holds the start button in place on a ford Tarus. This was modeled on a 2010 Sho model. Slightly reinforced. Printed in PLA could be printed in something stronger. I did not use supports for the arch part. The part is not available except with the entire trim piece for an extraordinary amount of money.