Headlight dust cover latch fix for BMW X3 e83 - image

Files (2)

e83_headlight_dust_cover_fix.3mf

3MF

4.6 MB

e83_headlight_dust_cover_fix.stl

STL

20.3 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

2 model files

Typical selected file

241g

Based on 90% main infill for the largest likely-needed model file

Material cost

$5.79

Filament only at roughly $24/kg PETG / ASA

Print time

6.9h–11h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 90%	100% solid	Recommendation
e83_headlight_dust_cover_fix.3mf	Cover / cap	4.6 MB 3MF	55g $1.31	121g $2.90	130g $3.12	Use PETG / ASA; check sealing faces and verify in slicer.
e83_headlight_dust_cover_fix.stl	Cover / cap	20.3 MB STL	109g $2.62	241g $5.79	260g $6.24	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Headlight dust cover latch fix for BMW X3 e83

0 downloads42 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is to replace the latch on the dust cover for the BMW e83 headlights, clean off the old latch pieces and just slide this in. Dust cover part number 1305239123 It holds nicely even if not glued. If you prefer, you can also glue it to the dust cover, it will however make it difficult to open the cover when you need to change the bulbs. Use support blocker to change the bottom 3mm or the protruding part to have 80-100% infill. I will not ask for money like others do. Have it, it's free. I will not be responsible if your car/house/hair/eyes/baby catches fire or are stolen, you print and use this at your own peril.