Holder for trailer hook electric adaptor (Seat Ibiza 6J) - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Holder for trailer hook electric adaptor (Seat Ibiza 6J)

0 downloads37 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

I needed a good place to store my 13 to 7 pin adaptor for the trailer hook's electrical connector on the car. It is a Seat Ibiza 2010. I came up with this little holder that attaches with the left rear lights fastening screw. - Remove the original fastening screw (keep it somewhere...) - Put on the printed distance washer on the lamp's screw - Put on the printed holder - Put on an ordinary washer and a M6 nut to keep it all in place. (Make sure you can remove the nut "road side" in case you need to change a bulb.).