Honda 13 inch wheel center cap. (blank) - image

Files (1)

Honda_Cap.STL

STL

84.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Honda_Cap.STL	Cover / cap	84.3 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Honda 13 inch wheel center cap. (blank)

0 downloads43 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Took the old 'tired' (aka beat up) full wheel covers off my Del Sol and wanted a simple cap to cover the center hole. This cap fits the Honda 13" wheel and is a good foundation for any logo you want to add to it. I probably will play with adding stuff to this later but here's a good starting point for you if this is the sort of thing you're looking for. Note, I printed mine in a fluorescent yellow (what I had loaded while testing the print) and in the end really liked the glowing dot look.