Files (2)

Gear_Shifter.stl

STL

4.6 MB

Gear_Shifter_Cap.stl

STL

2.0 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 40%	100% solid	Recommendation
Gear_Shifter.stl	Printable file	4.6 MB STL	Slice file	Slice file	Slice file	Use a slicer to determine optimal support structure, focusing on the bottom taper
Gear_Shifter_Cap.stl	Cover / cap	2.0 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer, but likely needed for the bottom taper.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Honda Civic Gear Shifter

0 downloads88 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

a friend of mine asked for a race style gear shifter that he could put weights in, it is fully knurled across the whole length and the knurls are the exact same size and pitch and can line up when the cap is screwed on, the only post print processing required is to run a M10 tap through it (i used a full set of starter, medium and full threaded taps as to not break the plastic) i printed mine out of Eryone Galaxy PETG and have heard no issues i also reinforced the walls towards the thread just in case, i would also like to say print at your own risk and i am also not liable for your gearstick breaking if mishandled, i recommend adding supports but only applying them to the bottom taper since its footprint is so small, and just support blocking out the top thread support, i also recommend adding another support blocker and changing the per model settings on the M10 thread and increase its wall thickness.