Improved GPS/TTPMS display mount for 2020 RAM - image

Files (2)

Lock_clip.stl

STL

32.9 KB

RAM_GPS_Bottom.stl

STL

347.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Lock_clip.stl	Clip	32.9 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping
RAM_GPS_Bottom.stl	Printable file	347.1 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Improved GPS/TTPMS display mount for 2020 RAM

0 downloads27 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a mount for a 8" tablet, a Garmin RV 890, and a TST 507 Trailer Tire Pressure Monitor (TTPM). It's an improved version (radically improved) of https://www.thingiverse.com/thing:4674715. This one puts the GPS, the heavy part, as low as possible to reduce vibration. There is the main part, RAM GPS Bottom, and a small clip that helps hold the mount down.