Iphone 12 holder for VW PASSAT B7 (perhaps also B6) models - image

Files (2)

hold_clip_1.stl

STL

103.6 KB

iphone12_hold_1.stl

STL

138.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
hold_clip_1.stl	Clip	103.6 KB STL	Slice file	Slice file	Slice file	Print with the holder's base flat on the print bed for optimal adhesion and minimal warping.
iphone12_hold_1.stl	Printable file	138.4 KB STL	Slice file	Slice file	Slice file	Print with the holder's base flat on the print bed for optimal adhesion and minimal warping.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Iphone 12 holder for VW PASSAT B7 (perhaps also B6) models

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Includes 2 screws with nut. M6 14mm with nuts will fit. The assembly is sqeezed in under the panel at the watch in the car which will keep it in place without damaging the car panel. You can adjust to volume on the phone etc. through the holes in the groove where the phone is standing. Both holder and phone will stand securely under all kinds of driving. Printed in PLA (could be better print quality). Both pieces where standing on the side (as the part viewer is showing) for good build up during printing without the need for print support.