Files (3)

jag_cubby_final_-_hubcap_logo_for_cubby-1.STL

STL

3.1 MB

jag_cubby_final_-_jag_xf_phone_cubby-1.STL

STL

204.3 KB

jag_cubbyv2.STEP

STEP

3.7 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
jag_cubby_final_-_hubcap_logo_for_cubby-1.STL	Cover / cap	3.1 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
jag_cubby_final_-_jag_xf_phone_cubby-1.STL	Printable file	204.3 KB STL	Slice file	Slice file	Slice file	Ensure the phone holder's design fits your specific phone model
jag_cubbyv2.STEP	Printable file	3.7 MB STEP	Slice file	Slice file	Slice file	Ensure the phone holder's design fits your specific phone model

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Jaguar XF X250 Phone Holder RHD

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Jaguar XF X250 right hand drive (UK, Cyprus, Aus, Japan etc) phone holder for a BV9900 phone. None of the designs i could find allow the odd shaped "cubby" to be closed when not in use, this design does, I've spruced it up a bit with a jaguar coin, I printed the main body with my ender 3 (FDM) and the coin with a MSLA printer for a bit extra detail, waste of time as my painting is terrible! I've uploaded the step file (should be universal) and the STLs but If your having difficulty modifying my design for your phone give me a shout. I put a hole in the bottom so a cable could be attached but I couldn't really figure out a good way to get around the issue that my phone has a flap over the USB/charging port, If i had a normal phone i'd of done cable routing and a way to hold the usb-c plug in place, but I don't so i left it blank, it does however mean the whole thing is easy to fish out the cubby.