Files (2)

light_holderv1.3MF

3MF

33.3 KB

light_holderv1.STL

STL

115.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
light_holderv1.3MF	Mount / bracket	33.3 KB 3MF	Slice file	Slice file	Slice file	Ensure the 1/4-20 nut is properly embedded in the printed part
light_holderv1.STL	Mount / bracket	115.7 KB STL	Slice file	Slice file	Slice file	Ensure the 1/4-20 nut is properly embedded in the printed part

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Jeep light

0 downloads25 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a bracket designed to rigidly mount a LED light from autozone to the tire rack. I do not know the exact light but it has an 8in center to center hole spacing with 8 LEDS. Use a 1/4-20 nut in the printed part, and 8/32 screws to mount the light.