Jeep passenger-side replacement handle - image

Files (1)

jeep_handle.stl

STL

564.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 50%	100% solid	Recommendation
jeep_handle.stl	Primary model	564.7 KB STL	Slice file	Slice file	Slice file	Print with supports at the ends where the handle tilts up off the bed

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Handles

Jeep passenger-side replacement handle

0 downloads25 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

It's just a tad unrefined, but when the passenger-side inside handle on my vehicle broke, I had a devil of a time finding a replacement part. Well it is a 25-year-old Jeep Grand Cherokee, after all. Anyway, I wanted it fixed so I whipped this up in OpenScad. Should fit a Jeep Grand Cherokee of circa-1994 model year, maybe other nearby model years as well. Print with supports at least on the ends where it tilts up off the bed. Also, because it's a handle, better than 50% infill is recommended: I did mine with 80%. If you live in a hot climate, consider printing it in ABS so it doesn't melt in summer temps.