Files (1)

Jeep_Door_Bumper_v5_Tall.stl

STL

38.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Jeep_Door_Bumper_v5_Tall.stl	Primary model	38.9 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is clean and level for proper adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Handles

Jeep Removable Door Savers

0 downloads30 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a simple little clip for the bottom of my TJ doors. I snap them on just before removing the doors so I can set them on concrete or sand without damaging the paint. Be sure you wipe the dirt and grime off before using. They protect the bottom of your door from what you set your door on but if your door is dirty they will scratch it up.