Kia sportage 2007 Sunvisor stopper - image

Files (2)

Left_side_SunVisor_stopper_left_side_V2.stl

STL

45.1 KB

Left_side_SunVisor_stopper_right_side_V2.stl

STL

45.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Left_side_SunVisor_stopper_left_side_V2.stl	Choose left variant	45.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
Left_side_SunVisor_stopper_right_side_V2.stl	Choose left variant	45.3 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Kia sportage 2007 Sunvisor stopper

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

A common problem with 2007 Kia Sportage's Sun visor is that the tensioning system fails over time and the Visor falls down, usually at an uncomfortable level. Because my sun visor would not stay closed, I decided to make to make a clip that keeps it closed. This is my second version, and should hold better even if temperature warping occurs. NOTE: Use materials that are UV and Heat resistant (eg. ABS, Nylon or PETG).