Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Miata plug for AFM delete

0 downloads34 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Decided to make this because I prefer this over spending 20€ and waiting 3 weeks or 50€ and waiting 3 days, turned out surprisingly well and decided to put it on here in case anyone else could make use of it. My print didn't turn out too well because my bed is warped to the point where my effective capacity has shrunk to a small square in the center. Use a low layer height for it, the print in the pictures had it set to 0.3 and you should probably use ABS for this. Once you got the wires where you want them you should put some hot glue over the top of the clamp thingies to truly keep everything in place, I originally intended for just the clamps to hold everything which they do well but because your print results will vary I'd recommend to just glue it in place. Legal disclaimer: I am not a licensed Mazda tech or any licensed anything for that manner, I will not be held liable for any possible damage that may occur to your vehicle or yourself during the installation or during operation.