Mitsubishi ASX (2012) phone mount - image

Files (2)

02032018.stl

STL

263.9 KB

clip030318.stl

STL

47.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
02032018.stl	Printable file	263.9 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation to minimize supports
clip030318.stl	Clip	47.9 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Mitsubishi ASX (2012) phone mount

0 downloads43 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Its a phone mount for a Mitsubishi ASX. There is a little bag for (in this case) the garage remote control. There is no phone holder equipped. I used a purchased phone holder for a 1,7 cm ball head mount. I used the clips to fix the phone mount to the fans. So there is no need for glue or something else...