Files (1)

Mk7_R_phone_mount.stl

STL

2.9 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Mk7_R_phone_mount.stl	Mount / bracket	2.9 MB STL	Slice file	Slice file	Slice file	Ensure the phone mount is oriented to minimize supports in your slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Mk7 VW Golf phone mount

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of the cell phone holder for Tiguans. Turns out it fits just fine in my Mk7 Golf R. I remixed it to use aTechMatte magnetic phone holder. I ended up using an M3X15 screw cap hex with a 5.45mm head on it. If you use anything shorter it might not reach the threaded mount. As I'm 6ft (182cm) the angle that the phone sits at is perfect for me. Bare that in mind if your several inches taller or shorter than this as it may not be the best viewing angle for you.