Files (1)

Model_3_Front_Trunk_Leveler.stl

STL

217.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Model_3_Front_Trunk_Leveler.stl	Primary model	217.4 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Hood

Model 3 Front Trunk Leveler

0 downloads25 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Front trunk (bonnet) lid on my Model 3 doesn't sit level. Adjusting the screw-in rubber fittings only got me so far. This sits on the car trim and can be stacked to increase thickness (raised pins with inverse underneath to stop shifting), allowing the screw-in rubber fittings a higher platform to contact raising that side of the front trunk (bonnet) lid. Automotive tape for bottom, superglue between layers. Printer is actually a Prusa Mini+.