Model 3 frunk reinforcement part - image

Files (1)

Refuerzo_pieza_tapa_frunk_V7.stl

STL

3.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Refuerzo_pieza_tapa_frunk_V7.stl	Primary model	3.6 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Model 3 frunk reinforcement part

0 downloads25 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

ENG:The Tesla Model 3 frunk has two parts (1131205-00-C) that are poorly designed and break easily when you remove the panels on the frunk area and place them back. I designed a part that holds inside the defective part and should avoid breaking the original part. You have to place the original part inside this part and place it on the original location. ESP:El frunk del Model 3 tiene dos piezas (1131205-00-C) que están muy mal diseñadas y se rompen fácilmente al quitar y poner el panel del frunk. He diseñado esta pieza en la cual se introduce la pieza original, la cual queda reforzada. Luego tienes que poner el conjunto en la misma posición donde se encontraba la pieza original.