MR2 Spyder Center Console Upgrade - image

Files (3)

mr2ConsoleBase.stl

STL

240.9 KB

mr2ConsoleVert0Hole.stl

STL

97.7 KB

mr2ConsoleVert2Hole.stl

STL

114.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
mr2ConsoleBase.stl	Printable file	240.9 KB STL	Slice file	Slice file	Slice file	Ensure a clean and level print bed for proper adhesion
mr2ConsoleVert0Hole.stl	Printable file	97.7 KB STL	Slice file	Slice file	Slice file	Ensure a clean and level print bed for proper adhesion
mr2ConsoleVert2Hole.stl	Printable file	114.1 KB STL	Slice file	Slice file	Slice file	Ensure a clean and level print bed for proper adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

MR2 Spyder Center Console Upgrade

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a Center Console for an MR2 Spyder (MR-S in some countries). The base contains a cupholder and a phone holder, both lower than the stock cupholders, thus improving clearance for the radio. The vertical piece fits on top of the base and has two holes designed for 3cm accessory ports such as a CLA and a USB. This upgrade requires the removal of the ashtray and pull out cupholders. This does not require the removal of the existing center console. This first draft is not a perfect fit, but I'll try to update it with a better fit in time. Fitment can be improved around the existing center console. The cupholder tapers as it goes down to compensate for the existing center console taper. EDIT: I have fixed the tab on the vertical piece and it should now fit with 2mm of wiggleroom. I also uploaded a no-hole version.