Files (3)

Miata_arm_rest_back_half.stl

STL

2.2 MB

Miata_arm_rest_front_half.stl

STL

1.2 MB

Miata_arm_rest_peg.stl

STL

746.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 25%	100% solid	Recommendation
Miata_arm_rest_back_half.stl	Printable file	2.2 MB STL	Slice file	Slice file	Slice file	Print each half standing straight up with the split facing down onto the bed for optimal results
Miata_arm_rest_front_half.stl	Printable file	1.2 MB STL	Slice file	Slice file	Slice file	Print each half standing straight up with the split facing down onto the bed for optimal results
Miata_arm_rest_peg.stl	Printable file	746.4 KB STL	Slice file	Slice file	Slice file	Print each half standing straight up with the split facing down onto the bed for optimal results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

NA Miata Armrest

0 downloads40 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement armrest for the center console portion of an NA Mazda Miata. Mine cracked so I designed this to take its place. I never got it fully printed before I unfortunately had to let the Miata go. The fitment should be correct as both halves were printed and set in the car but never fully mounted together with the pegs. It is split into 2 pieces in order to fit my print bed on a Wanhao Duplicator I3. I was going to fit it together with the pegs and glue to two halves once fitment was verified. I printed each half standing straight up with the split facing down onto the bed. I printed with supports. I recommend ABS as I'm not sure PLA or PETG would stand up to sitting in the heat of the sun in the car. Good luck! I hope it fits. If it needs some tweaking just let me know and I can provide my model files. This was designed in Fusion 360.