Files (4)

miata_nd_phone_mount.stl

STL

847.3 KB

miata_nd_phone_mount2.stl

STL

2.3 MB

miata_nd_phone_mount3b.stl

STL

5.4 KB

miata_nd_phone_mount_cover.stl

STL

1.6 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
miata_nd_phone_mount.stl	Mount / bracket	847.3 KB STL	Slice file	Slice file	Slice file	Print the main body part flat on its back with supports for the parts touching the build plate
miata_nd_phone_mount2.stl	Mount / bracket	2.3 MB STL	Slice file	Slice file	Slice file	Print the main body part flat on its back with supports for the parts touching the build plate
miata_nd_phone_mount3b.stl	Mount / bracket	5.4 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
miata_nd_phone_mount_cover.stl	Cover / cap	1.6 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

ND Miata Magnetic Phone Mount

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a phone holder which uses cheap 1.26" neodymium magnets from Amazon. They are really only 1.1" so that is the dimensions of the cover for the magnet. It should fit perfectly snapping into the crevices of the Miata just under the screen and above the controls over the hazard light button. If you need to use the hazard lights, I would just remove it. The phone would still hold in place without the magnet, but it's much more secure with the magnet. There is a hole on the bottom which should allow you to run your USB cable thru it. For the main body part, print it flat on it's back with just supports for the parts touching the build plate.