Oneplus 5 and 5T holder with charging for Ford Mondeo MK4 - image

Files (3)

OP5T_Clip.stl

STL

116.0 KB

OP5T_Holder.stl

STL

133.0 KB

OP5T_Plate.stl

STL

113.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 35%	100% solid	Recommendation
OP5T_Clip.stl	Clip	116.0 KB STL	Slice file	Slice file	Slice file	Print the clip with supports to ensure proper formation
OP5T_Holder.stl	Mount / bracket	133.0 KB STL	Slice file	Slice file	Slice file	Print the clip with supports to ensure proper formation
OP5T_Plate.stl	Printable file	113.1 KB STL	Slice file	Slice file	Slice file	Print the clip with supports to ensure proper formation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Oneplus 5 and 5T holder with charging for Ford Mondeo MK4

1 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a holder for Oneplus 5 and 5T with original case. It fits the original Oneplus charging cable and can be mounted directly to Brodit's tilt-swivel mount. The fit is very snug with 5T+case but also a slighly narrower Oneplus 5 fits well and doesn't fall off. The holder itself is a remix of gjlobb's design with a few modifications to dimensions and design to fit better with the clip and plate assembly. With the clip and the plate you can install the holder to Ford Mondeo MK4 (and probably several other cars, too) without any permanent marks on the dashboard. It is assembled using 4 screws. Everything were printed with PLA. I printed the clip with rafts and supports and 100 % infill. The plate and the holder were printed with 50 % infill without supports or rafts to make sure everything is sturdy.