Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Porsche 718 Cayman GoPro mount

0 downloads30 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a two piece mount for a GoPro clip in adapter to mount in a Porsche 718 Cayman. Slide the clamp over the bar behind the seats push in the clip and the slide in the GoPro adapter. It doesn't wobble and shouldn't slide. if it is a little loose the you could possible add a strip of electrical or similar tape to the inside of the clamp to reduce the clearance. The one shown was printed at 0.35 for speed but I would recommend 0.2 or lower if you want it to look good. The parts should be printed vertically and don't try and print too fast or it will most likely knock the part over on the print bed. I have added plain versions of each part without logos.