Porsche 911 LED Brake and 3rd Brake Board Frames and Clips - image

Files (4)

911_Coupe_3rd_Brake_Clip_RT_8.STL

STL

51.6 KB

911_Clip_14.STL

STL

46.5 KB

911_Periscope_Clip_6.STL

STL

87.4 KB

911_Brake_Inside_Frame_9.STL

STL

24.4 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

4 model files

Typical selected file

16g

Based on 40% main infill for the largest likely-needed model file

Material cost

$0.38

Filament only at roughly $24/kg ABS / another high-temperature tolerant material

Print time

27m–45m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	ABS / another high-temperature tolerant material 20%	ABS / another high-temperature tolerant material 40%	100% solid	Recommendation
911_Coupe_3rd_Brake_Clip_RT_8.STL	Clip	51.6 KB STL	10g $0.25	14g $0.33	24g $0.58	Ensure the inside window-mount frames are positioned to sit flat on the platter with the bottom edge at a slight angle.
911_Clip_14.STL	Clip	46.5 KB STL	10g $0.24	13g $0.32	24g $0.57	Ensure the inside window-mount frames are positioned to sit flat on the platter with the bottom edge at a slight angle.
911_Periscope_Clip_6.STL	Clip	87.4 KB STL	12g $0.28	16g $0.38	28g $0.67	Ensure the inside window-mount frames are positioned to sit flat on the platter with the bottom edge at a slight angle.
911_Brake_Inside_Frame_9.STL	Accessory piece	24.4 KB STL	9g $0.21	12g $0.28	20g $0.49	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Porsche 911 LED Brake and 3rd Brake Board Frames and Clips

0 downloads170 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

These clips are used to secure the Spokeworks LED boards in a Porsche 911 Rear brake and 3rd Brake Fixtures. Fits model years 1969-1989. The 3rd brake frames fit periscope/snorkel and inside window-mount fixtures. The inside window-mount frames must be a Right and Left pair. Only the Right side frame is attached. The Left side frame can be realized in the slicer program by mirroring the right side. The inside window-mount frames also must be positioned to sit flat on the platter. The bottom edge is flat but at a slight angle. These clips must be made with ABS or other material with as high or higher temperature tolerance. PLA is not a good fit for this application.