Pre-LCI (06-08) Xenon Projector Bracket for Halogen Headlights for BMW vehicles - image

Files (1)

E9X-Projector-Bracket-with-Demon-Eye.stl

STL

9.9 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

172g

Based on 90% main infill across listed model files

Material cost

$4.12

Filament only at roughly $24/kg High-temperature plastic such as PEEK / PEI / / a high-temp resistant filament

Print time

4.9h–8.1h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	High-temperature plastic such as PEEK / PEI / / a high-temp resistant filament 20%	High-temperature plastic such as PEEK / PEI / / a high-temp resistant filament 90%	100% solid	Recommendation
E9X-Projector-Bracket-with-Demon-Eye.stl	Mount / bracket	9.9 MB STL	78g $1.86	172g $4.12	185g $4.44	Ensure good cooling and airflow to prevent overheating

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Pre-LCI (06-08) Xenon Projector Bracket for Halogen Headlights for BMW vehicles

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

WARNING!!! I recently found out the projector gets TOO HOT for the HDPE and my bracket melted slightly, enough that it was drooping down in the headlight. I am currently machining the bracket out of aluminum, but wanted to leaves these files up in case someone could print in a high-temperatue plastic. This bracket solves the problem of mounting an H1 mini-style projector in a BMW E90/E91 pre-LCI housing, due to the low beam hole being offset to one side. It also assures that the projector is mounted in the correct vertical and rotational position for E46-R extended shrouds (https://www.theretrofitsource.com/e46-r-extended-48771.html). It is designed specifically for the ACME Super H1 bi-xenon projectors (https://www.theretrofitsource.com/bi-xenon-acme-super-h1.html), but may fit earlier versions of the Morimoto mini, and some other generic H1 projectors. Also included are mounting blocks for ACME RGB LED demon eyes that slide into the top rectangle of the bracket.