Prise USB pour VW T5 - USB outlet - image

Files (2)

support_USB_T5_v2_left.STL

STL

3.0 KB

support_USB_T5_v2_right.STL

STL

3.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
support_USB_T5_v2_left.STL	Choose left variant	3.0 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
support_USB_T5_v2_right.STL	Choose right variant	3.0 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Prise USB pour VW T5 - USB outlet

0 downloads35 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

English below ___________ Dans l'objectif de mettre des prises USB à la place de cache plein sur le tableau de bord de mon Volkswagen T5, j'ai dû créer un "étrier" pour maintenir l'USB contre l'arrière du cache sans interférer avec le mécanisme de branchement/débranchement. L'étrier est prévu pour ce modèle d'allume-cigare-USB: https://a.aliexpress.com/_v7du4F Le perçage doit être parfaitement centré sur le cache. Note: imprimer le plus fin possible (0.10 était très bien pour moi). Pour le maintien des prises, encoller les étriers de colle Epoxy et les coller contre le cache. __________ In the purpose of putting USB outlets to the middle dash panel of my VW T5, I had to design a bracket for mounting the USB PCB on the cap. The cap is designed for this car USB charger model: https://a.aliexpress.com/_v7du4F The cutout has to well centered on the cap. Note: print at a fine layer height (0.10 was fine for me). Put Epoxy glue on the bracket and apply against the back of the cap.