Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Ram 1500 Fog Light Fix

0 downloads50 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

The Fog Lights on my 2016 Ram 1500 were rattling and moving to the point that the light beam was distracting as it jumped around. I have seen others who put a zip tie through the worn hole to snug things up but I didn't think that would help much for my truck. The pins on the lamp housing had worn through in one side. One of each file is needed to repair each lamp. They press on by hand with significant force. The angled one is for the side where the pin is not perpendicular to the housing surface. You need to make sure it is indexed properly (if it doesn't slide into place rotate it 45 degrees and try again). The holes in the bracket must be drilled out to 5/8" diameter.