Raspberry Pi Carputer Case for 1990 Honda Civic V1.0 - image

Files (6)

back_louver.STL

STL

120.0 KB

Bottom_plateCase_assembly_V2.0.STL

STL

105.7 KB

LHS_Side_Plate.STL

STL

146.4 KB

RHS_Side_Plate.STL

STL

146.8 KB

screen_frame.STL

STL

118.7 KB

Top_plate.STL

STL

45.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

6 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
back_louver.STL	Printable file	120.0 KB STL	Slice file	Slice file	Slice file	Ensure proper cooling for the PETG/ASA print
Bottom_plateCase_assembly_V2.0.STL	Printable file	105.7 KB STL	Slice file	Slice file	Slice file	Ensure proper cooling for the PETG/ASA print
LHS_Side_Plate.STL	Printable file	146.4 KB STL	Slice file	Slice file	Slice file	Ensure proper cooling for the PETG/ASA print
RHS_Side_Plate.STL	Printable file	146.8 KB STL	Slice file	Slice file	Slice file	Ensure proper cooling for the PETG/ASA print
screen_frame.STL	Printable file	118.7 KB STL	Slice file	Slice file	Slice file	Ensure proper cooling for the PETG/ASA print
Top_plate.STL	Printable file	45.2 KB STL	Slice file	Slice file	Slice file	Ensure proper cooling for the PETG/ASA print

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Raspberry Pi Carputer Case for 1990 Honda Civic V1.0

0 downloads130 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a Carputer case I designed to be mounted on top of the dashboard of a1990 Honda Civic. The Carputer utilizes the official 7" Raspberry Pi display. There is a total of 6 panels to build the full case and screws used were 4x40. For my first prototype I used PLA, however in the near future I plan to make some minor modifications and reprint using PETG.