Files (1)
Based on 40% main infill across listed model files
Filament only at roughly $24/kg PETG
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
| STL file | Role | Source size | PETG 20% | PETG 40% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| clio4_shift_knob.stl | Primary model | 810.6 KB STL | 26g $0.61 | 34g $0.83 | 61g $1.46 | Use 'Fuzzy skin' in Cura under 'Experimental' for texture |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Renault Clio shift knob
Shared by
3DPrintedCarPartDescription
This is a shift knob i made based on the Clio's IV shift knob and used this: https://www.thingiverse.com/thing:4815629 as a start. Stock gear pattern silver plastic fits in flush with double sided tape underneath it but will need some trimming since i couldn't make the grooves required. I tried to get it as close as i could to the real thing using meshmixer and i made it 5-10mm shorter. Also has an 11mm hole and 4 holes for M4 grab screws to secure it. (I recommend tapping them first then screw in the screws, layers might get seperated if you go too hard) Important: Print using ''Fuzzy skin'' in Cura under ''Experimental'' to get the texture, infill is up to you,but PETG is recomended to withstand hot weather without melting. Feel free to remix it and share it if anyone gets it more accurate Have fun!
Compatible Cars
Originally published on thingiverse.com by nick melissas (nikosmls) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
