Saab 9-3 (OG - 1998-2003) convertible wind deflector mounting grommets - image

Files (1)

convcap.STL

STL

347.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
convcap.STL	Cover / cap	347.4 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Saab 9-3 (OG - 1998-2003) convertible wind deflector mounting grommets

1 downloads49 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

These grommets replace the stock ones on the first generation Saab 9-3 convertible. When the wind deflector is installed, it has 2 pins that insert into holes in the interior rear side panels. When the interior was redone on my car, the plastic grommets that lined these holes were lost / broken, so I designed 3D-printable replacements. Unlike the originals, these do not require any installation hardware, they just clip into the holes.