Seat Back Latch - GM GMC Chevrolet Yukon Suburban Tahoe Avalanche - image

Files (1)

Seat_Back_Latch_-_GM_GMC_Chevrolet_Yukon_Suburban_Tahoe_Avalanche.stl

STL

11.5 MB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

50g

Based on 100% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA / / ABS

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA / / ABS 20%	PETG / ASA / / ABS 100%	100% solid	Recommendation
Seat_Back_Latch_-_GM_GMC_Chevrolet_Yukon_Suburban_Tahoe_Avalanche.stl	Primary model	11.5 MB STL	21g $0.50	50g $1.20	50g $1.20	Print on the side as oriented in the model for optimal strength

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Seat Back Latch - GM GMC Chevrolet Yukon Suburban Tahoe Avalanche

0 downloads254 views0 likes

Shared by

Michael Chen

Verified

Description

I loved the original design, but with my seat backs, the lip was just a little too short to hold up when hitting bumps. And once I started modifying it, I went a little further and upgraded the design a bit! These are pretty easy to replace, just slide the pin out and get these in place! Needlenose pliers are a must. For printing, print on the side as oriented in the model. Print at 100% fill and you shouldn't need supports. I printed at 0.2mm layer height with zig zag infill. It is very very strong and should last a long time. For heat tolerance, make sure to use PETG, ABS, or ASA. When you print yours, print out a spare or two just to have, even a couple to give away! Many of these break due to the terrible OEM design.