Slotted GMC Sierra/Chevrolet Silverado iPhone Mount (2014 to 2018 with center console) preview

Files (1)

Phone_Mount_-_Phone_Mount.stl

STL

277.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Phone_Mount_-_Phone_Mount.stl	Mount / bracket	277.6 KB STL	Slice file	Slice file	Slice file	Ensure the v-slot configuration is suitable for your printer's support generation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Slotted GMC Sierra/Chevrolet Silverado iPhone Mount (2014 to 2018 with center console)

0 downloads32 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in a car environment

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of Penobscot's outstanding iPhone mount design. I added v-slots to the mount and v-posts to the back of the phone holder to allow for rigid assembly. With supports, I was able to print a great looking 2-piece assembly with no need for glue. I also added 1 mm to the width of the mount as it was every so slightly too tight for my Apple leather case. I printed in PETG, assembled, and drove a 44 hour road trip with my phone securely loaded in the base. I absolutely love Penobscot's original design, great work. In addition, I added a "cord plug", that can be printed in flexible filament, I used blue TPU. After inserting the cable through the hole in the bottom of the mount, wrap the flexible cord plug (assuming you're using a genuine Apple lightning cable) around the lightning connector and press-fit it back into the hole. That way you'll have a one-handed insert and removal of the phone, and the phone will "dock" in the mount. STEP files included if you chose to modify. If I were to re-do this design, I'd flip-flop the v-slot configuration so the slots are on the iPhone holder and the posts are on the mount base. This way it would be easier to print with fewer supports. Category: Automotive.