Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| body.stl | Primary model | 323.7 KB STL | Slice file | Slice file | Slice file | Ensure the model is oriented to minimize supports |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Smaller simple car phone holder
Shared by
3DPrintedCarPartDescription
This is a remix of Kilinich's Simple car phone holder (vent). So go over there and check that out. His creation was a perfect fit for my P10 but the original creation was not intended for my car. There were some problems. The size, it was to big and would be in the way of the volume knob. The arm which latches on to the vent was a bit too long and the hook would not attach easily. So to suite my car I needed to adjust it. This remix is about half the size in height. The hook is a bit shorter and it has been adjusted too hook on easier on my vent. Toyota Proace & Proace Verso.
Compatible Cars
Originally published on thingiverse.com by Ke Ni (knetazor) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
