Subaru Forester 2015 CB Mount (RHD) - image

Files (2)

Copy_of_Epic_Jofo.stl

STL

43.1 KB

Copy_of_Epic_Jofo_1.stl

STL

29.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 35%	100% solid	Recommendation
Copy_of_Epic_Jofo.stl	Printable file	43.1 KB STL	Slice file	Slice file	Slice file	Use a solid print for the final part
Copy_of_Epic_Jofo_1.stl	Printable file	29.4 KB STL	Slice file	Slice file	Slice file	Use a solid print for the final part

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trim Pieces

Subaru Forester 2015 CB Mount (RHD)

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Mount to install a Uniden CB mount in place of some decorative trim. Use a solid print for your final part, mark & pre-drill where the factory trim's clips are and attach with screws. This part fits a 2015 Forester RHD. It should suit later models. For LHD users, I *assume* you can flip the model and print but can't say for sure. I've attached STLs for both single and dual DB holders.