Subaru Impreza Headlight Washer Cover Bracket - image

Files (1)

HeadlampWasherBracket.stl

STL

282.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
HeadlampWasherBracket.stl	Mount / bracket	282.0 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Subaru Impreza Headlight Washer Cover Bracket

0 downloads65 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Clip to hold the headlight washer cover on for a Subaru Impreza (2010 model). Depending on your tolerances, you might need to trim it down slightly with a stanley knife. Holding firm on my car now though. Note: For installation it is easier to pull the receptacle forward (out of the car a little), fit the bracket and then attach the cover to the bracket. Then just push everything back inward.