Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| No printable model files are available for an estimate yet. | ||||||
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Subaru Outback BP turn signal connector dust cover
Shared by
3DPrintedCarPartDescription
I have bought white/yellow WY21W switchbacks for DRL on my 06 Outback. I do not like to see connector unprotected or covered by electrical tape. So I made simple cover that also hold resistor (M3 screw) and could by mounted with M6 bolt or ziptie. Hole for wires is sealed with hot glue / silicon sealant. On left side I had some empty holes on bracket behind batery so I could mount it with screw. On righ side I had to mount it with zip tie on back side of bracket between headlight and airbox.
Compatible Cars
Originally published on thingiverse.com by Not Fill (Woyta) · License: CC BY-NC-SA
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
