Files (1)

Subaru Outback Cup Holder Riser.stl

STL

690.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 35%	100% solid	Recommendation
Subaru Outback Cup Holder Riser.stl	Mount / bracket	690.2 KB STL	Slice file	Slice file	Slice file	Print with the open side down to minimize support needs

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Subaru Outback Cup Holder Riser

0 downloads7 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in car conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

supports unlikely

Infill

20-50% infill for balance of strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a copy of the cup holder insert that came with my car. It was very useful, but it only came with one, but there were two cup holders, so I modeled and printed my own. TPU would be best to match the factory insert, but PETG, ASA or other high temp plastic would be best for the car. For best results print upside down, no supports needed. Added chamfer the edges of corners and writing to make things print nicer and come off the bed easier. Works great, I've printed a few for friends.