Subaru Outback two-way radio mount and cup holder preview

Files (1)

CarRadioStorageSupportx2.stl

STL

32.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
CarRadioStorageSupportx2.stl	Primary model	32.4 KB STL	Slice file	Slice file	Slice file	Ensure a secure fit to the passenger-side centre storage area

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Subaru Outback two-way radio mount and cup holder

0 downloads7 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in car conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance of strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Subaru Outback owners who wish to mount a two-way radio have limited options for placement, particullarly without drilling/modifying the car. I've made this hanging radio mount that also incorporates another cupholder. It hangs off the limited-use passenger-side centre storage area. This is also a reasonably easy location to feed the wiring to. It fits the BT Outback perfectly, I can't say if it would work on older models. It's sized for a small GMC radio (100mm x 25mm), but the included step file should be easy to size to whatever small radio you've got.