Files (1)

jimny cup holder driver.stl

STL

8.4 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 60%	100% solid	Recommendation
jimny cup holder driver.stl	Mount / bracket	8.4 MB STL	Slice file	Slice file	Slice file	Print with the cup holder upside down

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Suzuki Jimny Cup holder V2

0 downloads38 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

60% infill for durability

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

Public Domain

Commercial use allowed

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Cup holder for a JB74 Suzuki Jimny. It mounts in front of the air vent on the drivers side (RHD model). Mounts with one M8x 25mm allen head bolt. Simply remove the stock cover “bolt" and screw in the real bolt. Printed upside down with supports from PETG. When using super slicer by default it wants to put supports in the vent holes. Its worth taking the time to not support the vent holes as it makes support removal very difficult and with the new rounded hole it doesn't need it. Updates: Rounded vent holes so support isn't needed there. Also added a left hand side model to match the other one. I printed the at 60% infill because I found over time the PETG around the bolt hole will deform and make the bolt loose.