Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

0 model files

Recommended kit

—

Based on 25% main infill across listed model files

Material cost

$0.00

Filament only at roughly $24/kg PETG / ASA

Print time

—–—

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Swing Out Table Mount (Foot & Bracket)

0 downloads37 views0 likes

Shared by

Verified

Description

Bought a swing out table for my VW campervan but it only came with one set of brackets. I wanted to put brackets in more than one place in the van so I could have one table and move it around. Replicated the parts in the kit. Takes an M6 nut and bolt. I printed in ABS Should work on any swivel table with a leg that has a 4cm hole in the middle and 2mm wall thickness This is the table I bought: https://www.ebay.co.uk/itm/Swing-Out-Side-Wal-Mounted-Table-Leg-Kit-VW-T5-Campervan-Motorhome-Table-Leg/253320401763?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

Published Jun 29, 2026Updated Jul 15, 2026

Originally published on thingiverse.com by Dan Bot (breakbot) · License: CC BY-NC

Verified by drivers

Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.

Loading fitment proof…

Comments (0)

Part lists

Save this part to named public or private collections. Public lists can be shown on this part page.

Finding specific fitment/category matches first.